Thanks Ron maybe it’s orange with a white stripe? I’ll have to clean it up more. If I’m reading the wiring diagram right brown would be for power door locks which my ranger doesn’t have
I noticed a broken wire coming off my starter relay. It’s yellow off the relay then splits into 3 fusible links which are all 20ga. And then all 3 wires go into main harness.The broken/green crusty wire looks to be brown with white stripe? I can’t find this wire in the wiring diagrams, can...
Ron thanks for the help! I finally got it to stop leaking, took a Roloc wheel to the intake where the oring seats and got nice and clean. Been a couple days, no leaks yet.
I just got done doing a new water pump, thermostat and new radiator. Always had trouble with the oring sealing on thermostat housing. Sure enough slapped it together using permeates thermostat and water pump gasket maker on outside flange away from oring sealing surface followed instructions on...
What’s confusing me is the oring would seal against a gasket and not the water neck if a gasket was used also. Wouldn’t it be a better seal without it?
The Hayes manual shows a thermostat oring and gasket being used on the 2.9. I was wondering if the factory service manual shows the same? I’ve always had a problem with the waterneck leaking eventually when just using an oring.
I’m looking for some disc brake dust shields for 1st gen ranger with 4 wheel drive. Think it’s a Dana 28. Also need a turn signal switch.
Im in Connecticut,thanks!
Was able to get it aligned. If anyone in Connecticut is having trouble finding an alignment shop I recommend Flanders alignment in Hartford’s south end.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.