Recent content by KevinSonOfDad

i did try cleaning that area with laquer thinner and putting rtv on it but it didnt seem to help

im hoping not as removing that would likely damage the gasket i have there and leave the rubber tabs stuck next to the rear main cap

i was meaning if when i put the timing cover on i didnt center it properly. (I dont remember if it has dowels). i also polished the harmonic balancer before installing it so that shouldnt be the issue. ill see if i can get the balancer pulled off in the next week or so and take a look. it could...

Hello folks! Its been a while since I've posted here (no problems with the truck since the clutch knock on wood). However I recently built a new motor for it last august (high compression, valves, springs the whole deal) however ever since I installed it I've had a small leak coming from what...

its not as much that as it is that i need SO many parts. the engine i bought came with no wiring no sensors no oil pump no alternater etc. i need so many parts and i also realized that even tho it would be rad im only 19 and saving money is more important right now.

Ok gents.... Been a crazy few months but unfortunately its time to move on. Im selling my 2jz shortblock (dm if interested) and moving onto smaller projects around the house and mainly getting my current daily ranger finshed restored. Im only 19 and the parts for this engine are just too pricey...

it also has a new master already. it was bled in the past and then replaced with a prefilled master. I have a new line but i dont want to put that on and contaminate it with fluid from the slave if neccesary. important note is my clutch feels perfect when its cold but after 15 to 30 minutes of...

Hey all! unfortunately im back with more clutch and transmission problems. looking to fix them for good this time. First of all my clutch worked fine when cold but when hot it wouldnt disengage all the way. (looking over the forums sounds like thats a slave cylinder failure even tho i did that...

ok so some unfortunate news. my daily driver just had the clutch slave go out. 2j project is out while i source another daily and get my current ranger back up and running. i still plan to do the 2jz ranger swap but life has other plans for the next month or 2. i will keep the thread updated

Keep in mind i will also be relocating the battery and i am doing a electric ps rack so i will have plenty of real estate

It will be no where near that wide as well. Aftermarket intake is less wide and the turbo will be higher where the engine bay is wide.

It will be a full custom swap with making my own firewall and trans tunnel. Im going to MAKE it fit lol.

Lmao same. I will put bigger tires on it but traction will always be the weak point

Thats what other people seem to forget... 600hp in a 2500lb truck im.probably going to lose traction before i shred gears lmao

#bringbackboss