hey i have a 89 b2 manual tcase and i needed a front driveshaft so i went to the jy and got one off a 89 b2 auto tcase it didnt fit the splines where too big i thought the slip yokes would be the same?
i did a dana 35 axle swap on my 89 b2 i was just wondering if the caster/camber sleeve is the same? i would just go check but the trucks at a friends house
ok so when i jack the truck up and spin the tire whent the hub is free it spins fine but when i lock the hub it wobbles as i turn the tire this is on the passenger side could it be a bent axle?or bearings:icon_confused:
so im gonna start a build thread on my 89 b2 so far im in the process of doing a 8.8 and dana 35 swap out of a 94 explorer i got the 8.8 im and pinion angle set the shock mounts are on all thats left is the brake lines and e brake cable. i also have to hook up the d shaft i had to get a...
hey i have a 1990 b2 manual trans and im wontering about the drive shaft can i just get conversion joints from 1310 to 1330 and use the explorer flange?
hey i just bought a 89 bronco2 and it was missing the front drive shaft so i bought one and it hits the tranny x member at the u joint. i have a 6 " lift but i dont think thats making it hit it has bad motor mounts could that be causing the t-case to lean and make it hit?:icon_confused:
hey i just got a 89 b2 it has a 6" lift and the front diff is toast so i am planing on a dana 35 swap but the problem i have a plate style lift can i just cut it some and weld braces on? i also have a very leaky 2.9 should i rebuild it and but 5.13 gears in it or find a 4.0 its sittin on 33s now...
hey i have a 94 3.0 ranger that i put 4" skyjacker coils on but i cut them down a inch to get my alighnment close. i put jeep wrangler shocks on it but its bouncy as hell its like a pogo stick lol whats a good shock to dampen it some?
hey i have a 94 3.0 ranger and it wont start it has no spark.when i pull the ecu relay it sparks from the coil for a sec same with the fule pump it turns on for a sec then shuts off i cant figure out why any suggestions??
so i cant figure out why my lights aint working i made a custom ignition switch
cause i lost my keys and drilled the colom to shit my question is their wires on the ignition switch to power headlights my ambers work and the flash to pass works but no headlights?? And its on a 1994 3.0 5 speed
so i cant figure out why my lights aint working i made a custom ignition switch
cause i lost my keys and drilled the colom to shit my question is their wires on the ignition switch to power headlights my ambers work and the flash to pass works but no headlights?? And its on a 1994 3.0 5 speed
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.