Belt broke on 2000 2.5 ranger --- trying to get timing right
set crank to TDC and set oil sprocket diamond to diamond on backing plate
camshaft triangle to triangle on backing plate the diamond on camshaft backing plate is not center.
Started and runs but has a ticking sound in it
Thanks for...
Have 2000 ranger 2.5L , had engine rebuilt runs fine but keeps showing camshaft pos. sensor. All wiring checks out, timing is correct. The guy that rebuilt the engine says that the computer needs to be Flashed.
I can't remember where I was told this ,or if it is B.S. but the cam. shaft pos...
2000 2.5L ranger
engine has been rebuilt keep getting code PO3040 camshaft position sensor.
have checked all connections with meter , traced wires all checks out all good.
can clear code drive turn ignition off, start engine check light back on.
Engine runs fine.
Can't have truck inspected with...
Hello all
Have ? need some help
Have 2000 Ranger 2.5, rev up motor and back off motor runs rough
and will stop running. when running rough in key is turned off and then back on the motor smooths out.
Thanks
Ol Blue
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.