So I just found out that the ends or the o2 sensor connector are all bald and melted together and thats probably why I have the code P1152 on. I went to the local srap yard and took out a connector but when I went to install it from my Ranger I cut the old connector off now I don't know which...
I have a 1998 Ford Ranger XLT 4x4 4.0 v6 and I have a check engine light on that read to replace an o2 sensor before the catalytic in which i did but then I noticed that when I would put the truck in drive that is didn't have any take off power like it wouldn't smoke them out if I tried. I press...
1998 Ford Ranger XLT 4.0 V6 OHDV 4x4.
CEL on and the truck idles bad. It don't shut off but comes close to it.
So if I am not mistaken it's a oxygen sensor or a injector but my question is which one.
Please help I need it to pass emissions.
I bought a used trans at a junk yard today for my 1998 Ford Ranger 4x4 4.0 V6 however the donor vehicle is a 1999 Ford Explorer 4x4 4.0 V6.
My question is will it fit?
So I got the truck back from the mechanic after he did a complete rebuild on it.
The reason why I did the rebuilt was because the truck would feel that it was in neutral when I put it on drive so I would have to put the truck on 2 to take off then put it in drive and everything would be good...
I had a mechanic rebuild my transmission (5R55E) and he is now done. He gave me a call to tell me that the truck is done however that he needs to reset the ecu but that I can take it. He said he recommends not driving the truck hard in tell the ecu has been reset. He told me that it takes 2 to 3...
As a former Explorer owner I now sold my Ex and bought a 1993 Ford Ranger 4x4. I have a lot of plans for this little truck to lift, get bigger tires and upgrade mirrors and rear drums to disk breaks also get rid go those seats and get something better...
After buying this things turns out 3...
So Today I was under my truck about to crank the torsion when I noticed that in the front I have no coil spring at all just a shock. Should my 1998 Ford Ranger XLT 4x4 have some cold springs. If it should have some then I shouldn't crank the torsion right?
Im so confused as to why it doesn't...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.