I have gone through several starter motors bought from various retailers trying to get one that properly engages the flywheel on my 1988 Ranger XLT 2.9L Manual Trans. Unfortunately, none of them are doing the job consistently. I have had some luck with some shimming, but it never lasts. I am...
Okay so my rear driveshaft came off my 88 ranger 7.5". Pulled a new one off of a 94 ranger that will fit. Then I screwed up by pulling off the rear differential pinion nut without marking a reference. My questions are:
How do I know how tight to turn that replacement pinion nut?
How do I...
Shaft flew off yesterday. Whoops. It's slightly bent. Already have new U joints. Here's what I'm looking at:
Front:
Rear:
What do I need for that front part? I'm a bit surprise that is bolted together and not just a single machines piece...
Bought an '88 Ranger XLT 2.9L 4X4 standard transmission recently. I have had three starters crap out and am on number four (fourth in a week). All three of the first starters lost their ability to engage the fly wheel (a lot of whirring). This most recent starter had installation instructions...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.