TrapperMan2024
New Member
- Joined
- Apr 27, 2024
- Messages
- 2
- Reaction score
- 1
- Points
- 3
- Location
- Minnesota
- Vehicle Year
- 1986
- Make / Model
- Ford Ranger
- Transmission
- Manual
Hey All-
I'm not sure if I'm posting in the correct spot (new to the forum), but I recently purchased a 1994 Explorer 4.0 to swap into my 1986 Ranger. The 4.0 donor vehicle has the interior gutted as the old owner was going to demo-derby it. The wiring inside the cab (by the steering wheel) was cut 14" out from the firewall so I have some wiring to work with...
I would like some help knowing which wires I need to 'hook up' to a simple lawn mower ignition switch to see if I can confirm that it runs. I have a Haynes manual and the switch but I dont know which wires to use...
I bench tested the starter and it works great.
Any help would be appreciated.
TrapperMan2024
I'm not sure if I'm posting in the correct spot (new to the forum), but I recently purchased a 1994 Explorer 4.0 to swap into my 1986 Ranger. The 4.0 donor vehicle has the interior gutted as the old owner was going to demo-derby it. The wiring inside the cab (by the steering wheel) was cut 14" out from the firewall so I have some wiring to work with...
I would like some help knowing which wires I need to 'hook up' to a simple lawn mower ignition switch to see if I can confirm that it runs. I have a Haynes manual and the switch but I dont know which wires to use...
I bench tested the starter and it works great.
Any help would be appreciated.
TrapperMan2024