Currently my 96 2.3 ranger is equipped with a 5x11 oval, 28 inch overall length, offset magnaflow universal muffler, stock shorty header, magnaflow "high flow" catalytic converter from summit (http://www.summitracing.com/parts/MPE-23389/), and a magnaflow tip from summit...
Ok, going to do the 2.3T swap and was trying to pick which after market header to use. Did some research here at the engineering library and found a book that stated that a supercharger, specifically a turbocharger on an auto, will gain energy the quickest when pressure waves simultaneously hit...
Alright i have a 96 2.3 2wd with a djm 3/4 lowering kit. It looks more like a 4/6 lowering kit after day one (measured 4/5 so far and shocks haven't settled yet). I reallllllly want to keep the positive rake/slope of the car if you're looking front to back from the drivers side. I also would...
Currently, the temperature control knob on my truck no longer functions. I understand that this is an electronic switch that goes to an electronically controlled motor that opens and closes the vent door to the heater core. The motor works, the housing that the motor sits in to open and close...
I looked for a lil while a couple weeks ago, and couldn't find a similar thread sooo: I would like to put wheels from a mach mustang (2004) on my 96 2wd? I know bolt pattern is the same but I'm worried about depth. Any help or experience with these wheels?
Thanks
Thinking about adding a 50 shot to my 96 2.3. Any thoughts, comments, suggestions, etc. so on and so forth????
Figuring a dry kit. Zex probably. Not too familiar with nitrous, but I figure I'll need an air/fuel gauge along with bottle pressure gauge. Any help is greatly appreciated
Also...
Hey guys. I have a 96 ranger 2.3 w/o a rear sway bar. It's in the shop right now and I don't know if the sway bar I yoinked at the yard will fit on it. The sway bar is of the rear end of an 89 Bronco II. Normally I'd just bolt it up, but seeing that I'm gettin 4.10's and an l/s in right now...
I know I shouldn't post this because I haven't searched the site for the answer, I know its in the tech library somewhere, but....
I found a 4.10 l/s 7.5 (axle: D7) out of an 89 Bronco II. I have a 96 2.3 Ranger with an open 3.45, 7.5. Is it a direct swap? If not, what mods need to be done...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.