I'm using an Explorer axle in a hot-rod application. There is a large flange on the center section casting along the passenger side. I guess I should say it's a large reinforcing rib. There are two holes about 3/8" diameter in it where something was bolted to it. I think it was a vibration...
I'm putting a 2.3L turbo motor from a Merkur XR4Ti in my Jeep J-10 pickup. The Merkur motor has a T-5 behind it now. 175 hp/195 ft-lb turbo four vs. the original 258 six 110 hp/200 ft-lb... Power is higher in the rpm range, naturally, but the 4.10 gears with 30-31" tires will fx that.
I've...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.