i recently bought a 2002 ford ranger 5 spd manual with the manual transfer case. (i dont know if thats rare or not) . I ended up having to replace the passenger side front hub assembly and the half shaft. The problem arose when i went to take the half shaft out. I got the end out of the spindle...
Im working on my 1998 Ford Ranger 4.0 4x4 5-speed.
I have the front axel that is long on the passenger side, and flat on the drivers side if this explains things. Im not sure if its a dana 35 or what.
Anyway... I need to remove the c clips on the passenger side to remove that internal shaft so...
I went out to change the front passenger side wheel bearings, everything came off just fine but the outer bearing was completely shot.. all that was left was the race. Pretty sure it is supposed to just pull off, but it wont budge. Tried beating it with a hammer, any ideas of where to go from...
hey guys,
i have a 97 4.0 4wd ranger
i have been replacing parts constantly
i replaced the front HUBS, then U-Joints
i now have a noise when i turn (gets louder with increase in speed)
my truck got a free inspection at pep-boys the other day and the guy showed me the things wrong with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.