- Joined
- Mar 28, 2017
- Messages
- 180
- Reaction score
- 17
- Points
- 18
- Location
- MS
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0L EFI
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
- Total Lift
- 4"
- Tire Size
- 31 X 10.5 X 15
- My credo
- Duty, Honor, Country
If you have a 1st Gen Ranger/Bronco II (87 in my case) 4X4, no body lift (I do have a 4" suspension lift), 302/5.0 with AOD trans, and have headers installed, what brand and model number of headers are you using?
If you have headers, did you have make any special modifications to get them to fit? Did you install them with the motor already in the vehicle? Any tips or suggestions?
I reviewed the "headers section" of this forum and found lots of conflicting or outdated info so any feedback will be greatly appreciated!
Thanks!
Mark
If you have headers, did you have make any special modifications to get them to fit? Did you install them with the motor already in the vehicle? Any tips or suggestions?
I reviewed the "headers section" of this forum and found lots of conflicting or outdated info so any feedback will be greatly appreciated!
Thanks!
Mark