ncsdaonex
New Member
- Joined
- Dec 5, 2008
- Messages
- 181
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1990
- Make / Model
- Ford
- Engine Size
- 2.3L 4 cylider
- Transmission
- Manual
i am replacing a manual tranny in a 1990 ranger 2.3L, the hydraulic clutch line that goes into the tranny, is there a trick to disconnect it from the slave cylinder or does it just pop out? Also how do you disconnect the hydraulic clutch line from the master cylinder?