79Camaro
New Member
- Joined
- Aug 18, 2010
- Messages
- 43
- Reaction score
- 0
- Points
- 0
- Location
- New Jersey
- Vehicle Year
- 1994
- Make / Model
- Mazda
- Engine Size
- 3.0L
- Transmission
- Automatic
My truck's (94 B3000) distributor is set incorrectly, I have been seaching for a few hours now for the corrct procedure to set the ignition timing, and have become a little confused. Heres what know
1. warm engine
2. connect timing light
3.turn distributor counter clockwise=advance/clockwise=retard
4.set at 10 degrees BTDC
5. tighten down distributor check timing again
Now what I dont know, Is there a wire I have to disconnect before setting the timing? Whats it called and where is it located? I have been dying to get this truck on the road. Any help is much appreciated.
1. warm engine
2. connect timing light
3.turn distributor counter clockwise=advance/clockwise=retard
4.set at 10 degrees BTDC
5. tighten down distributor check timing again
Now what I dont know, Is there a wire I have to disconnect before setting the timing? Whats it called and where is it located? I have been dying to get this truck on the road. Any help is much appreciated.