93Ranger4x4
New Member
- Joined
- Oct 11, 2007
- Messages
- 497
- Reaction score
- 1
- Points
- 0
- Age
- 39
- Location
- Southeast Ohio
- Vehicle Year
- 93, 96
- Make / Model
- Ford
- Engine Size
- 3.0, 4.0
- Transmission
- Manual
Welp, i've ran into a small snag. I'm gettin my 4.0 and tranny ready to swap into my 93, i'm replacing the clutch,pressure plate, and the slave cylinder, problem is, i can't disconnect the line on the slave cylinder. Says use the tool or screwdrivers and press the white plastic clip in and pull the line. Well, thereis NO white plastic piece in between the line and the slave cylinder. Short of just cutting the line off, anyone have some thoughts on how to remove it?