swynx
Active Member
- Joined
- Mar 26, 2008
- Messages
- 2,401
- Reaction score
- 9
- Points
- 38
- Age
- 31
- Location
- lewiston idaho
- Vehicle Year
- 1994
- Make / Model
- Mazda
- Engine Size
- 4.0
- Transmission
- Manual
so some time ago i grabbed some unknown manufacturer lift brackets off an older ranger. i put them on the pickup and realized that the passenger side shaft wasnt hitting the hubs, i could lock in the hub and it would still free wheel.
after looking, and measuring i found that the drivers side tire was about an inch or more pushed out and thats the reason for the shaft not contacting the hub.
i tryed to shim it up and bend the tabs on the bracket a bit, and i got pulled over about a 1/4 inch or so.
is this a common occurance?
after looking, and measuring i found that the drivers side tire was about an inch or more pushed out and thats the reason for the shaft not contacting the hub.
i tryed to shim it up and bend the tabs on the bracket a bit, and i got pulled over about a 1/4 inch or so.
is this a common occurance?