• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Back brakes are slightly engaged even when not braking


DroidTN

New Member
Joined
Nov 12, 2013
Messages
20
Reaction score
0
Points
0
Vehicle Year
1994
Make / Model
Ford
Transmission
Automatic
Hey guys, I have a 4.0 6cyl 94 Ranger. I recently had some shop work done including the back brakes. About 3 weeks later, my truck started to feel sluggish, one day it got worse. When starting from a stop I have to apply a good amount of gas to make it move. If I coast from 10mph, it will stop itself in about 50 feet. It feels like the ebrake is on, but its not. It is definitely coming from the back. Is there a way to release tension on the ebrake (to see if it is the ebrake itself) or to unhook the back brakes to troubleshoot? I am by no means a mechanic, so please be specific if you have suggestions to try :) Thanks!!!

Andrew
 


adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
Hop under and pull on the cable, see if you can feel or see movement from the rear cables. You could also pop the drums off, set the brake, and release it, see it's returning.
 

RonD

Official TRS AI
TRS Technical Advisor
Joined
Jun 2, 2012
Messages
25,292
Reaction score
8,298
Points
113
Location
canada
Vehicle Year
1994
Make / Model
Ford
Transmission
Manual
How far down does the E-brake pedal start to engage?
Should be a few inches before you start to feel pressure
 
Joined
Aug 10, 2011
Messages
159
Reaction score
3
Points
18
Location
MA.
Vehicle Year
1994
Make / Model
Ford
Engine Size
4.0
Transmission
Automatic
Sounds like your e brake cables are shot.
Just last year I had to replace them as I had roughly the same thing happening.
They lock on.
 

DroidTN

New Member
Joined
Nov 12, 2013
Messages
20
Reaction score
0
Points
0
Vehicle Year
1994
Make / Model
Ford
Transmission
Automatic
Can you just loosen the cable? If so, does that automatically let off the brake, or could it be stuck engaged even if the cable is looser?
 

adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
The cable has to hold tension on the arm or the springs inside the drum will return the brakes to their at-rest position. If the cable is loose the brakes should release.
 

alwaysFlOoReD

Forum Staff Member
TRS Forum Moderator
TRS Banner 2012-2015
TRS 20th Anniversary
Joined
Apr 13, 2009
Messages
13,872
Reaction score
5,031
Points
113
Location
Calgary, Canada
Vehicle Year
'91, '80, '06
Make / Model
Ford, GMC,Dodge
Engine Size
4.0,4.0,5.7
Transmission
Manual
2WD / 4WD
4WD
It could be that the e-brake cable is seizing inside the protective cover, that is common. When seized the brakes will not release. Do like adsm said and remove the drum. It may not be easy because the brakes shoes will be expanded onto the drum if the cable is seized. There is a rubber plug in the lower part of the backing plate that you can remove to access the star wheel. Use a flat screwdriver to turn the wheel until the drum turns easily then remove. Once off take a pic or memorize where the shoes are in relation to the backing plate. Push on the e-brake and the shoes should expand. When released they should go back to original. If not there are three possible cables to replace. Replace the seized one. I would replace all of them if not strapped for cash as it's likely the others are close to failing too. When replacing the drum use the screwdriver to turn the star wheel until a slight drag is felt on the wheel while turning the wheel. You can also go to a parking lot and drive back and forth as that will self adjust the brakes. If you plan on doing work on your vehicles buy a manual. The haynes or other cheap manual will pay for itself on the first brake job you do yourself.
Good luck,

Richard
 

adsm08

Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
Joined
Sep 20, 2009
Messages
34,623
Reaction score
3,613
Points
113
Location
Dillsburg PA
Vehicle Year
1987
Make / Model
Ford
Engine Type
4.0 V6
Engine Size
4.0
Transmission
Manual
2WD / 4WD
4WD
Tire Size
31X10.50X15
The backing up thing to adjust drum brakes is outdated, but does still work. Setting the parking brake will adjust them now as well.

Postin' from teh Galaxy
 

alwaysFlOoReD

Forum Staff Member
TRS Forum Moderator
TRS Banner 2012-2015
TRS 20th Anniversary
Joined
Apr 13, 2009
Messages
13,872
Reaction score
5,031
Points
113
Location
Calgary, Canada
Vehicle Year
'91, '80, '06
Make / Model
Ford, GMC,Dodge
Engine Size
4.0,4.0,5.7
Transmission
Manual
2WD / 4WD
4WD
The backing up thing to adjust drum brakes is outdated, but does still work. Setting the parking brake will adjust them now as well.

Postin' from teh Galaxy
Yeah, I'm close to outdated too :icon_surprised:
Good to know about the PB adjusting.
Thanks,

Richard
 

DroidTN

New Member
Joined
Nov 12, 2013
Messages
20
Reaction score
0
Points
0
Vehicle Year
1994
Make / Model
Ford
Transmission
Automatic
Ok, I finally got a chance to get underneath it. What is happening is when the ebrake is released the cable isn't being full released. I cna pull on the cable at the split joint towards the rear axle and it continues to move about 1/2". That seems to fix it. The spring seems very weak, as in, inable to pull the brake cable back to fully off. The question is..is the problem, the spring possibly or just replace the entire cable and assembly?

Andrew
 

Sponsored Ad


Sponsored Ad

Staff online

Today's birthdays

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Kirby N.
March Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top