YungICY
Member
- Joined
- Jul 19, 2013
- Messages
- 339
- Reaction score
- 1
- Points
- 18
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Size
- 2.3
- Transmission
- Manual
A while back I gutted my entire truck and was going to dedicate it to a off road only vehicle. Well now I have decided to make it streetable again and I am just finishing up wiring up all the exterior lights headlights, turn signals etc. I'm all done except for the brake lights. I can't figure out how to make them work in unison with the turn signals. I'm pretty sure if I wire them up how I thought they were supposed to go I will have a working brake like and hazard lights any time I hit the brake pedal with the turn signal on.
I have been following the diagrams I found in the tech articles but even though they show me exactly what I need I can't read a schematic any further than switches, lights and wire color.
Here is a pic of what my turn signal switch looks like. Bottom wire is power in, two sides terminals are left/right. The way I was going to run it for brake light was power to brake switch, to one of the turn signal power outs, with a jumper to the other turn power out. But I'm pretty sure that will void out the left right switch.
Any help is appreciated and I'm sure you'll need more info so just let me know what you need.
Thank you.
Sent from my LGMS345 using Tapatalk
I have been following the diagrams I found in the tech articles but even though they show me exactly what I need I can't read a schematic any further than switches, lights and wire color.
Here is a pic of what my turn signal switch looks like. Bottom wire is power in, two sides terminals are left/right. The way I was going to run it for brake light was power to brake switch, to one of the turn signal power outs, with a jumper to the other turn power out. But I'm pretty sure that will void out the left right switch.
Any help is appreciated and I'm sure you'll need more info so just let me know what you need.
Thank you.
Sent from my LGMS345 using Tapatalk