koda6966
Well-Known Member
- Joined
- Nov 28, 2007
- Messages
- 7,898
- Reaction score
- 61
- Points
- 48
- Location
- The green part of NY.
- Vehicle Year
- 1988
- Make / Model
- Ford
- Engine Size
- 2.9
- Transmission
- Automatic
I've been wanting to customize the case on my Dell for quite some time. It's a nice little computer, but it's ugly. I even squished a fly on it and was too lazy to clean it off while I was taking this picture.
At first I was just going to tear into it and leave about an inch around the metal, glue some plexi to it, add some vent holes, put in a few LED's, and call it done. But now that I get looking at it that isn't possible. Here's why.
If you can't tell why from that picture, it's because there is a very limited amount of open space left to show off the internals. This is obviously because it is the slim version of the 530, and has a vertical disk drive/less room for components/etc.
I'll be throwing up some ideas on the design and mostly using this thread to organize them and look around at the possibilities. Feel free to comment with any suggestions you might have.
At first I was just going to tear into it and leave about an inch around the metal, glue some plexi to it, add some vent holes, put in a few LED's, and call it done. But now that I get looking at it that isn't possible. Here's why.
If you can't tell why from that picture, it's because there is a very limited amount of open space left to show off the internals. This is obviously because it is the slim version of the 530, and has a vertical disk drive/less room for components/etc.
I'll be throwing up some ideas on the design and mostly using this thread to organize them and look around at the possibilities. Feel free to comment with any suggestions you might have.