Southenrfirewood
New Member
- Joined
- May 23, 2012
- Messages
- 84
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1998
- Make / Model
- ford
- Engine Size
- 3.0
- Transmission
- Automatic
My 98 ranger 3.0 4x4 automatic will no longer run water. When I splash into a puddle the truck will start running poorly or will keep stauling out. After a while of running dry ground it clears up. I have put electronic grease on every electrical connection I can find. The CPU and fuses box is covered with scilicone and the intake is snorkeled into the cab and had been check for leaks. Im not sure what the deal is. Iv had this problem for a while. Any ideas? When it starts running rough I can unplug the MAF sensor and it will clean up for a few min then it runs rough again, But the MAF sensor is clean. Is there something im missing? How hard is it to convert it to a carberated engine?