• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

O2 sensor issue


Tyler M

February 2014 MTOTM
MTOTM Winner
Joined
Apr 10, 2009
Messages
50
Reaction score
1
Points
0
Location
Calgary AB, Canada
Vehicle Year
2011
Make / Model
Ford
Engine Size
4.0L
Transmission
Manual
I've been trying to replace the O2 sensor on my 90' Ranger but the darn thing just does not want to come off. I've tried an open-end wrench and O2 sensor socket with liquid wrench and the exhaust warm but nothing works.:temper: Any suggestions would be greatly appreciated.
 


Z3CHYD

Active Member
U.S. Military - Active
U.S. Military - Veteran
V8 Engine Swap
Joined
Dec 11, 2008
Messages
1,342
Reaction score
17
Points
38
Age
33
Location
Lancaster, PA
Vehicle Year
03
Make / Model
Ford
Engine Type
2.3 (4 Cylinder)
Transmission
Manual
2WD / 4WD
2WD
Total Drop
3 front 5 rear
Tire Size
225/60R15
Best i can say is get some PB Blaster and spray the piss outta it, let it soak for a couple hours and try it again. I had to use pb blaster and an inpact wrench on my o2 sensor on my 86 ranger
 

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top