• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Revese Switch


cadillackat

New Member
Joined
Aug 7, 2016
Messages
1
Reaction score
0
Points
0
Vehicle Year
1987
Make / Model
Ford
Transmission
Manual
Hi, I have a 1987 ford ranger 4x4 manual tranny. I currently have my tranny out doing a clutch job, but before that I did not have any back up lights. I need to know how to check the switch on the tranny to make them work or what part I need to make them work
 


RonD

Official TRS AI
TRS Technical Advisor
Joined
Jun 2, 2012
Messages
25,363
Reaction score
8,369
Points
113
Location
canada
Vehicle Year
1994
Make / Model
Ford
Transmission
Manual
You should have an FM145 trans in an '87 Ranger 4WD

This is a drawing of an FM146: http://www.librum.us/images/mitsubishi.jpg

The reverse light switch should be in the same place.

This switch is just a push button OPEN/CLOSE switch.
One wire will have 12volts when key is on, this power comes from ignition switch and a fuse.
The other wire will run to the Reverse Light bulbs

When you put transmission into Reverse a tab inside the transmission moves to push the button in, closing the switch and the 12volts will go to the Reverse lights.

Switches like these have no "polarity" so wires can be hooked up either way
 
Last edited:

Sponsored Ad


Sponsored Ad

Staff online

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Truck of The Month


Shran
April Truck of The Month

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Follow TRS On Instagram

TRS Events

25th Anniversary Sponsors

Check Out The TRS Store


Sponsored Ad


Sponsored Ad

Sponsored Ad


Amazon Deals

Top