Shotokan1509
New Member
- Joined
- Aug 28, 2007
- Messages
- 208
- Reaction score
- 0
- Points
- 0
- Location
- CT
- Vehicle Year
- 95
- Make / Model
- Ford
- Engine Size
- 4.0 V6
- Transmission
- Automatic
My apologies on cluttering the general board with a specific question but I'm stuck. Got the spindle bolts off, but the abs sensor is in the way. I took the bolt off the back of the electrical connector, how do I get the sensor to slide back? Can I push from the outboard side or will I ruin the sensor? Second, how do I get the block around the sensor off the outside of the spindle? I see a small bolt, but its completely round from rust.