-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Recent content by Danny Rominger
-
1999 Ranger Head Bolt question.
OK I see it has been moved. Hopefully will get more views and responses. And no the bolts didn't come with instructions. So I think I might be OK but just not sure. I looked up the Felpro head bolts that I bought and few websites says they're TTY but most don't mention it. Even Felpro.com...- Danny Rominger
- Post #6
- Forum: 3.0 Liter Forum
-
1999 Ranger Head Bolt question.
OK thanks for your reply. Just new to this forum and learning it. I will try to find that section and re issue the question.- Danny Rominger
- Post #4
- Forum: 3.0 Liter Forum
-
1999 Ranger Head Bolt question.
That last step #4 to tighten to 73 lb-ft. Is that the yielding?- Danny Rominger
- Post #2
- Forum: 3.0 Liter Forum
-
1999 Ranger Head Bolt question.
Had to replace heads on 1999 ranger 3.0 engine. Got new head bolts (Felpro ES 72174) and I have the Ford 1999 Ranger workshop manual book 1. On page 303-01B-104 in that book it says to 1- tighten bolts, 2 - loosen bolts, 3 - tighten again, then 4 - tighten again. I used the max numbers on that...- Danny Rominger
- Thread
- Replies: 6
- Forum: 3.0 Liter Forum