-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Recent content by Lerad92explorer
-
Axle spacer washer wearing.
I was thinking of just machining my spindle a bit shorter. Say a 16th or 1/8 of an inch off. Then there isn't as much pressure on the spacer. It sucks living in an area with 5 months of snow or icy roads and have these hub issues. I see now why my Dana 28s never had the locked in hub...- Lerad92explorer
- Post #10
- Forum: Transfer Cases & Locking Hubs
-
Axle spacer washer wearing.
Or is there some after market fix?- Lerad92explorer
- Post #6
- Forum: Transfer Cases & Locking Hubs
-
Axle spacer washer wearing.
Can a guy convert to the flat bearing washer like the Dana 28?- Lerad92explorer
- Post #5
- Forum: Transfer Cases & Locking Hubs
-
Axle spacer washer wearing.
I have had quite a few B2's, early Ranger 4x4s and now my 1st Explorer. A 92 4dr 5spd, manual transfer case and manual hubs. On any of my TTB Dana 28s never ever wore one out. My Explorer on the other hand. I have gone thru 2.5 sets of those splined axle shaft spacers. Did gear/swaps from...- Lerad92explorer
- Thread
- Replies: 15
- Forum: Transfer Cases & Locking Hubs