UPDATE: I did a few ground test. I dont think its a ground issue. So I went under the dash and poked around with the multimeter and honestly didnt find anything out of place. Will do more testing later. I did run a jumper wire from a 12v HOT on run to the HEI "B" and it ran and stopped...
I will say I didn't test all of that but all throughout the tests. Ive tested the battery voltage before and after starting and running. They all read 12.75 (Not running) and 14.25 (when running).
I'll run a direct ground from the battery, engine, and the HEI once I've got wires and the...
I looked everywhere for a Ballast Resistor under the hood and under the dash. Nothing.
A idea that I had was splitting the 2 wires and running the 12v run (red/light green wire) and running it directly to the HEI "B" post. Since its only powered with key on RUN and the (Brown/Pink wire. Mine...
I need to get some reels of wire as Im out. Then Im gonna get a ground block so I can ground everything to the battery. I currently cant do anything with it sadly.
Im gonna re run my grounds on my ignition just so everything is clean.
I tried that. Then I remembered I had run a engine ground directly to the engine block when I was dealing with voltage drop issues when I was dealing with my starter.
Same for me... Yeah, as far as I know. I added extra ground to the coil, dizzy, and HEI when I put all together. Maybe some of the grounds need to be redone but idk.
Ok, so I found the wires. Pain in the ass to find, honestly. Do I need to remove one of them from the splice? Because that's that I'm getting I have to do.
I havent done anything yet...
If possible. Could someone post a photo of where that looks like and where its coming from? So I know which harness I could be looking at and for tomorrow? I keep getting the urge to wanna mess around with my truck tonight but its late, dark, and humid as a swamp outside...
I honestly dont remember what the original wire colours were. I tired looking on the dead horse of a thread (The one that started my conversion and that included every horrible step I too haha) but I couldn't find photos of the wires. I found that diagram you had sent me but that was all I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.