• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Recent content by Maggrett

  1. Maggrett

    No power issue 1990 2.9lXLT...need advice

    **Update: My power issue was indeed clogged catalytic converters. They finally blew out after going on the highway (got so tired of being stuck in town). Truck has tons of power now...and I have many new parts. I'm so glad this is over and I thank everyone for their help.
  2. Maggrett

    No power issue 1990 2.9lXLT...need advice

    @gaz not previously. I have now replaced the fuel pump, filter, and injectors, IAT sensor and still no luck. It takes longer to start now than previously. The problem is now intermittent. Today I drove on the highway with good power. Once I turned around, it went back to limpy, gutless, slooow...
  3. Maggrett

    Tfi connector question

    Gotcha. So, which pin does it connect to the TFI module? Mine has no black wire going to it atm.
  4. Maggrett

    Tfi connector question

    Thanks Uncle Gump. The diagram shows a black wire from the tfi, but my harness doesn't have a black wire on the connector. Its the one that is wrapped around three others inside the insulated loom. Not sure where its supposed to go.
  5. Maggrett

    Tfi connector question

    I got a pip circuit failure code and checked my harness. I found the black wire spliced together which terminates before the tfi module. Is this supposed to go to a ground or is it correct? It looks like it is wrapped around three other wires inside its own loom, then just stops. Pics included...
  6. Maggrett

    No power issue 1990 2.9lXLT...need advice

    I am in Colorado, BTW. I've driven up and down Wolf Creek Pass in a snowstorm in my 1967 T-Bird (no longer have it). It was an adventure.
  7. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Hello. I have not found a solution as of yet. Replaced the injectors, distributor, gaskets. Have not found the problem. I have a new fuel pump on the way in. My new problem is it running OK when starting, but losing power and shaking when warmed up. I'm taking a break from it before I go insane.
  8. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Yep, just changed the filter, correct flow.
  9. Maggrett

    No power issue 1990 2.9lXLT...need advice

    I just changed the plugs and same symptoms. I will do a compression test and post the results.
  10. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Yep, throttle cable is taut. It still seems variable. Sometimes I had power on the highway without much effort and others it was excruciatingly slow with the throttle floored. I think I will pull my tank and see if there is crap on the sock.
  11. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Thanks Uncle Gump. I'm starting to think I just have a tired old engine. Drove 120 miles, without much power, buy solidly.
  12. Maggrett

    No power issue 1990 2.9lXLT...need advice

    I will say that my throttle cable was stretched pretty well. Taking up the slack improved tĥe situation a bit, but it still lacks uphill power.
  13. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Not sure if there is something I'm missing so I posted a video. Anyine notice evidence of exhaust restriction or the like?
  14. Maggrett

    No power issue 1990 2.9lXLT...need advice

    Thanks for your time Uncle Gump. I appreciate you. Tomorrow I will go back out and redo the vacuum test. My pressure definitely is a bit off. Wondering if something else is causing it to dip further when I'm on the highway. Will do the checks and report back. Thanks!

Sponsored Ad


Sponsored Ad

Top