Recent content by pintobobster

Tried the LED turn flasher, no change

Yes it works when brakes are compressed, But with the light staying on, cruise control not working,

Please explain more.

UPDATE 02/09/2023 Ok so I pulled (disconnected) all taillights, Multiswitch, headlight switch, rheostat,. Turn ignition on(did not start Ranger) high brake light "not" on, Start Ranger high brake light "is" on, Only comes on when truck is running, Next step, Tear into ALL grounding sections...

Great suggestions, I will start looking at the connections and the areas of grounding related to the lights. Anyone have a good link to wiring schematics for a 1996 Ford Ranger? I have both the Haynes and Chilton, not much help for those areas. Thank You all again, Robert.

I will pull the trailer wiring out and just Connect the factory harness back up. I'll let ya know results, Can a video be posted on this site do you know? And thank You for the reply, Robert.

Ok, 1996 Ford Ranger STX 4wd automatic transmission 4.0L engine, Is the vehicle that is having the lighting issues. I also have LED tail lights and LED high third brake light on my 1995 Ford Ranger XLT, the 1995 is having no issue at all with LED Lighting. I've been racking my brain trying to...

Good Afternoon All, Whelps..... My 1995 Ford Ranger XLT 4x4 Automatic V6 4.0L gave up its ghost the other day, Looking to replace the motor, What year Rangers or Explorers or V6 4.0L will be a direct swap replacement?? Not interested in the rebuild of the existing motor, just want to R&R the...

Thank You, I will dig into that this next weekend,

Thank You, This is for the cargo lamp, The 3rd brake light breaks off and goes to the Exterior lighting Wiring Diagram.

Thank You for the reply, I replaced the switch and I have bypassed it. Disconnected the switch at the brake peddle completely and the 3rd brake light still came on when the ignition switched to on.

To access the ground for the 3rd brake light, would I need to pull the whole headliner off to gain access? Or where is this grounded at? I do not see any grounding at the area of the light itself, Just the three wires, Brake, Cargo light, and ground.

Good Afternoon All, :shout: 1995 Ford Ranger XLT 4WD Automatic 4.0L Issue I am having. 3rd brake light slightly comes on "only when ignition is turned on", when brakes applied it does get brighter as should be. no engine light (CEL), no other light issues, brake lights work, turn signal...

Got my cruise issue repaired, found out that speed control cutoff switch was issue (the recall fire issue) here is what I found part number# Motorcraft SW6350 which says fits and works for the 1995 ford ranger 4.0 engine is "INCORRECT" (after replacing this part three times) part number#...

Just did mine, remove belt pulley first, I took serpentine belt off before some people say leave it on? (use the tool OTC 4530 or OEM 27031), take off three bolts holding pump to bracket, pulling out down the out the top, replace with new pump, replace three bolts back on, use same tool put belt...