Recent content by Rangergirl92

Yeah I need to do more inspect/diagnosis but when i do eventually (regardless) replace the radius arm I will make a vid or pictorial how to

Correct assumption lol thanks for the link!

Oh I forgot to add: 1992 125" wheelbase 4x4 TTB with Dana 35

A few years back I replaced all the rubber in my front end with poly when I rebuilt my front axles. I found a small rub wear point where the radius arm meets the mounting bracket on the truck's frame. Then she had motor problems and had to sit while I used a commuter trying to save up for...

Hey y'all, Any meetups or off road clubs for Colorado folks? Would love to get my Ranger back out in the mountains - she needs a radius arm so not fully up to par but I can do greens and mild blues on trail ratings. Love camping, fishing, climbing, skiing, and mountaineering and would love get...

Hey y'all, I installed a new electric cooling fan system with a thermostat controlled activator. I am adding a relay into the system to help reduce electrical load, but also to incorporate a signal circuit from the A/C pressure switch. I have a 1992 4.0L with the factory A/C installed. All...

Hey @gaz Thank you for the recommendation. Is that model from Summit racing an exact fit or do I need to prepare to do some modifications to get it mounted properly? Thx - rangergirl92

Okay everyone, first I wanted to thank you all for your recommendations and insight - it has been very helpful in reassessing nad finding the right parts for this upgrade! I have decided to do the following: I am picking up a 16" 8-blade fan with a 3000 CFM max output for $50. I can easily...

Hey thank you for the information and clarifications. I made a mistake it is actually a 13" 8 blade fan kit: https://www.lmctruck.com/1983-11-ford/cooling-system/fr-electric-cooling-fan So could I get little "L" brackets to adapt the factory shroud then? Where can I find such brackets? Hardware...

CORRECTION: it is a 13" 8 blade fan kit from LMC truck. I bought the thermostat as well. It has an output of 1560CFM.

It was a kit I got from LMC truck's website. The fan is 13",8 blades with an output of 1560CFM https://www.lmctruck.com/1983-11-ford/cooling-system/fr-electric-cooling-fan

I bought an electric cooling fan from LMC truck to take load off the motor and improve hp, mpg, torque. I got all those benefits and they were better than id hoped! But the motor gets up there in temps now. She's a 92 so the gauge has L to H with a "normal" range. Sits fine on highway. A/C...

Hi all, So I have been desperately searching for the oil level sensor connector for my 4.0L OHV but it's almost impossible to find. I know its a discontinued part and all that noise so yeah. OE Motorcraft part numbers: WPT-237 or 3U2Z-14S411-TA Any suggestions on where to find a new one...

Hey Ron, Thanks for the information, this was very helpful!!

I am lookimg to replace the single pane rear slider with a double pane rear slider in my 92 super cab. LMC truck has a double panel slider that comes pre-tinted: https://www.lmctruck.com/1983-11-ford/fr-1983-11-sliding-rear-window Only thing is, they are saying that the super cab model has to...