Recent content by saskboy

I can't detect any vac leaks, I checked compression again, all 130 on my gauge, fuel press KOEO 39, KOER 31. I ran engine for a few mins then shut off, started shortly after, won't start, just cranks, checked spark is ok, checked one plug, is wet with gas, tripped inertia switch then cranked...

Hey Ramcharger 90, I saw u had a setup similar to mine. I have 89 mustang engine all stock sensors, intake, Maf and TB and injectors. I swapped to Edel performer rpm heads and Trick Flow stage one cam. Idle is very rough, smoother at 2500 rpm but still not good, fuel pressure 39 psi koeo. What...

I installed a 5.0 and 5 spd into 1996 ranger, flywheel, pressure plate and disc are new, trans from 1989? f150, slave is what came on trans. Pedal effort seems normal, very little play at top, travel all the way to floor seems normal. I see this a common swap, does ranger master always work...

Hi, I have a Ranger now, 1996 2wd stepside std cab, was a 2.3 std trans. I installed the trans from underneath, m5od-hd fromF150, its a tight fit over the crossmember, I attached the motor to check fit, the mustang mounts don't seem to line up even if switched sides,angles wrong. What headers...

Are the stock exhaust manifolds from '70s cars or trucks worth doing on 302 v8 swap on 1995 Ranger, I know they are small but might work until budget allows better.

Info on mustang harness, I'm trying to run the engine ,5.0 on a stand while I am looking for a suitable Ranger 1994 or older preferred but probably will end up with a 1998/2002. So if I hook up TFI,coil,MAF,MAP,EEC relay TP sensor, IAC,fuel pump relay would it run? I found a chart on this site...

I have looked at a lot of swaps on here but most are using explorer motor and harness. I'm using a 1989 mustang harness and engine 5.0. When using this harness how will it intregrate into newer models, say 1998-2003. which suspension has more room for swap, torsion bar or control arms? I'm...

I can't seem to get my message in the right place.I want to get a 4x2 ranger with std trans, I have a m5od trans from a 1987 f150, a new flywheel and clutch assy, oil filter relocation kit motor mounts etc. 1994 and older rangers usually have rust, i don't want to do rust repair so thats why I...

We have no emissions tests here, so using 94 or older would be easiest. So if I find a good deal on a 2005, use the mustang harness and pcm to run the engine, modify the cluster to take aftermarket gauges or hang gauges under dash,what other systems would be affected? Just curious, to the...

older rangers hard to find here with no rust, apparently 2005 rangers didn't have pats,better vehicle for swap?