Unusual question I suppose since i couldn't find anything through search but, Is there a wider brake pad for the rear of the 8.8? So that it covers more of the rotor? i have an unsightly ring of rust on the rotor because the pad is only an inch or so wide. might just be me but its annoying lol
Basically I want to do air bags in the front on my 91. I want to keep a stock height. Has anyone done this? And how difficult? Do you have any pictures? No real reason other than my coils are getting bad. And it seems like it might be fun.
Thanks, Travis
does anybody know where i can get late model non-Ranger wiring diagrams? or maybe someone has an account with a website? I need the entire vehicle diagrams for a 2005 Ford Freestyle 3.0L FWD.
Also i need the wiring diagram for a Viper 5101 remote start/ Keyless entry. The one that came with is...
i havent posted much lately or even in the last year. But i have been working on a little project. I have been doing a motor swap in my 91. i was given a free motor and trans about a year ago, so i decided i would go ahead and get rid of my 2.3L. The motor i was given was a small block Chevrolet...
Just thought that this should be put in the tech section.
For the 2.3L engines
Some certain year Rangers ( I believe 93+) come with stock tubular headers. This is a cheap little upgrade from a junk yard. Mine cost 20 bucks. Only thing is the EGR is a PITA to put back together, this if you...
i would just like to add a little to the hi/lo beam mod. Just recently i did this mod and noticed that my wiring is a little different then what is stated in the tech article. Not much different but it can throw you off and to save anyone the hassle of melting wires and blowing fuses i figure i...
im not sure if this is where to post this at...but some how my frame is bent up in the rear and its making my rear end sit funny( one side is higher then the other). When i measure it its only about and inch but it make a significant impact on the appearence. Is there a way the pull it down and...
Has anyone tried this mod where you take the relay and wire it up so the low beams stay on with the high beams? How did it work and have you had any problems like melting wires or melting lamp housing?>
So i just installed a new water temp and oil pressure gauge. My queston is what is the water temp supposed to be at for normal temp and what is the oil Psi supposed to be at? Mt oil is reading 50 psi at idle the jump the 72 when i get on it. i know that i should have good pressure because i...
Has anyone put a rack and pinion steering on Ranger the came with a steering gear box? Have any pics? IM thinkng that this would eliminate all kinds of problems
tlane
So i went out today to get friction modifier for my 8.8 3L73 and when i asked for it they took me to a product called TRANS-X: POSI-TRAC Limited slip gear oil additive. did i get the right stuff? It has a Ford P/N on it: P/N M2C118-A
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.