I would start at where the initial work was done and look at all wiring that goes from cab to bed. +2 on Bird76Mojo reply.
I too need to replace or fix filler neck as I have the symtomatic filling problem at the gas station where I have to gently and SLOWLY fill the tank or gas spills out.
94 b4000. Can't find the darn thing anywhere??
There's nothing close to my oil filter, and if I look underneath on the other side close to the starter, I see what I believe is the temp sensor as I got a new replacement oil pressure switch and the threads are nowhere near the right size for...
Thanks for you prompt reply.
I think I would like to keep both tire sizes the same on the front and rear. I don't like the front looking dropped lower than the rear.
Hello all.
1994 Mazda B4000.
I need new tires. Right now I have 14" rims running with 195/70 on the fronts and 205/75 on the rears which seem to be with what the truck came with, stock.
No lift whatsoever.
I want to buy all new 15" rims and put new rubber on.
What would be the largest tire I...
Update: only does it in fifth Gear...
So today I started the truck up and idled it and went underneath and found two pretty small air leaks in the first CAT canister closest to the engine.
Just a small amount of air seeps out under idle.
Hello everyone.
I recently purchased a used 1994 Mazda b4000. I have cleaned the MAF and IPS. I was about to go on a trip a few weeks later and drove about 80 miles or so on mainly flat surfaces with small increases in rise and drops and started to drive up a fairly steeper grade hill. The...
Well, I live in what would be classified as the great white north, lmao. Fall/winter is hard on vehicles here even though I do reside somewhere where we dont have to live in igloos year round. I'll definitely consider fluid filming all my vehicles from now on.
I prefer manual transmission over automatic, always. Just cheaper and easier to repair.
How are the automatic transmissions in these 2000 - 2011 vehicles?
Thanks again everyone, really! My first foray into "Ford". I've always owned Japanese made vehicles. Loves their reliability but hated the cost of parts. I normally work on my own vehicles as a rule, but as I get newer, they get more difficult to troubleshoot and repair yourself. That worries...
So awesome! Thanks for all the advice and thoughts. I do understand that it's all really a matter of opinion, but people who have owned these trucks also have experience with them and knowledge that is usefull. Keep it up folks! This is a good little thread of useful knowledge.
As I'm getting...
Hello everyone.
I'm thinking of trading in my 94 Mazda B4000 for a Ranger.
I'm looking at 2011 SuperCab Sport models.
My main and troubling question is if this year of truck, as it is the last year of production for a few years, is a reliable option to purchase used.
Is there any years that...
Hello everyone,
Wondering who owns a 1994 b4000 with power door locks. Did this vehicle come stock with a key fob?
I bought a used one and would like to use one if I can.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.