this is my trailer tug that i am building right now it is a 1946 Studebaker m-16. I put a 300 ford in it with a t-18 trans. axles are heavy hub closed knuckle d44 and a gm 14 bolt with 13" brakes. right now my ranger has a higher priority over this build but after its done....
well I'm finally digging back out the old ranger for some more work I've been putting off for a while. As soon as i get the pad I'm going to work on in cleared off the front end is going to come out and get replaced with a jeep d30. Yes I know that the axle is weaker than a 44 but my trucks got...
Hello all my name is jim i live in northern California and drive a 89 ranger on its way to a total body overhaul. I am continuity surprised at the capability of this little truck. i have out wheeled solid axled toys with it no prob with just a 2" body lift and 33" muds. Unfortunately the only...
all ford trucks from the 70s to about 88 had left hand threads on the rear left wheel of the truck definably a dana 44 front. as for the rear the only dana 70s i know of instaled in a f250 where in the diesel trucks with the 6.9, then they switched to the 10.25 in 89. if its not diesel then its...
the only problem with swapping in a Dana 60 into a ttb truck is the spring rates. the f250 springs for the ttb are heavier that those on a f350 with a 60. also if you are looking for a front dana 60 look for the rare Canadian models that have taper roller bearings in the knuckles instead of...
i am in the process of gathering parts for this swap right now. what i planed on doing is using the links from a 8" Rubicon express long arm lift kit and making a track bar to keep everything aligned. the links convert the suspension from a 4 link to radius arms and make the install easier. as...
for 35" tires id go with the 44/60 combo, because I've broken diff gears with just 31s in my 8.8. there is also a better aftermarket for this combo and depending on the years of the axles you can get parts anywhere. Also if you run full widths with centered backspaced wheel, it is just as wide...
I've got a 89 ranger with a 2.9L engine in it and i was looking for some more horsepower for it along with better fuel millage. I am considering a cummins 4bt turbo diesel engine along with the drive train out of a 1 ton dodge pickup to help handle the power. I just need some input so i can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.