Search results

After going back & forth for the last 18 months, I finally decided to yank the 2.9L & the A4LD and go with a 5.0L swap. I need to find an engine & transmission. I'm thinking about a 1995 F150 5.0L with the 4R70W transmission as the replacements. I will have the transmission rebuilt and the...

I need a 200 amp alternator for my 1990 2.9L 2wd ac automatic. Any suggestions? Also, how do I tell what the stock alternator is rated at? I see that the 1990 2.9L came with 60,75 or 80 amp alternators.

I'm not sure where to post this question. If I'm in the wrong area, MODS please move. I would like to add a winch and a front hitch to my 1990 XLT Super cab Ranger. It has a 4" suspension lift. The front hitch is easy - Draw Tite 65017. The front winch is harder. What's the best way to...

I've been working on my 1990 XL Ranger Super cab for two years now. My wife finally took her first ride in it today :) ! I found the truck on Craig's List Atlanta back in June 2015 for $2300. It will be my HAM radio truck as I am an ARES member. My call is W1AJO - it's my license plate as...

I thought I'd report my speedometer changes when I swapped tires & wheels on my 1990 Ranger Super Cab 2WD. My Ranger Super Cab came with 14" rims and 215/70R14 tires and 3.45 rear end gears. I switched to 15" rims and 235/75R15 tires. Naturally this caused speedometer errors. Using my GPS I...

I need an accelerator linkage splash shield (plastic) that covers the accelerator linkage cables for the 2.9L V6 engine. I think the part number is E67A-9F766. It sit on the top of the engine a bit to the right of the intake manifold. The local junk yards do not have any or they are broken...

Google doesn't seem to know so I will ask it here: Will a 1993 Ranger Super cab gas tank (19.5 or 19.6 gallons, not sure of the exact capacity) fit in a 1990 Ranger Super Cab? My local wrecking yard has one but they are not sure. Thanks!

Does anyone have a GEN II Ranger 89-92 Super Cab that came from the factory with 235/75R15 tires? I would like a photo of the door label that shows the 235's. I'm having a technical discussion with a vendor about 235 sized tires. Thanks

Well my 1990 Ranger Super cab WAS made before 23 Oct 1989 as it does have the smaller 16.3 gallon tank. I ran it to the top of the RED E mark on the fuel gauge and then filled it up. It took 15.5 gallons before it overflowed. I'd like to swap in the larger 19.6 tank. Is the swap easy? Do...

I'm almost ready to buy a set of new rims for my 1990 Ranger Super Cab 2WD. I'm getting 15" size rims (stock for my 2WD is 14"). The tires I will be buying are Goodyear Wrangler Silent Armor 235/75R15. Should I get a 7" wide rim or an 8" wide rim? Will a 15x8" rim work OK or will the tires...

I'm upgrading my rear drum brakes from 9" to 10" with an 8.8" rear end swap for my 2WD 1990 Super Cab 2.9L. The specs on the brake master cylinders are: Master Cylinder: 4x2 models use a 0.938 inch master cylinder bore. 4x4 models use a 0.975 master cylinder bore...

I'm doing an 8.8" rear end swap into my 1990 XLT 2WD Super Cab and the donor rear end came out of a 1991 Ranger Super Cab. The drum brakes are 10" and the brakes were well rusted. I was able to track down most of the brake parts except for the pins that go into the wheel cylinder and engage...

Now that I've settled on 3.73 gears in my 8.8" rear end I'm getting closer to upgrading my wheels to 15" rims and 235/75R15 tires. I'm wondering if a 15" rim with a 235/75R15 tire will fit in my 1990 Super Cab XLT spare tire holder? It looks tight as it is with the 215/70R14 that in it right...

I'm stuck tearing down my 8.8" rear end. I can not loosen the bolts holding the flange to the pinion end of the drive shaft. Is there a special tool to remove these bolts? See red arrows: Thanks!

My project is a 1990 Ranger Super Cab 2WD 2.9L auto A4LD. I am doing the rear end swap for an 8.8" with 10" brakes as my truck came with a 7.5" with 3.45 (axle code 84). On Friday I finally found one at a wrecking yard after looking at 3 other yards in the area. No 8.8's to be found in...

I need some advice here. I just bought a 1991 8.8" open rear end with 3.08 gears & 10" brakes to swap into my 1990 Super Cab 2WD 2.9L Ranger with auto transmission (A4LD). My Ranger came with 3.45 gears in the 7.5" rear end with 9" brakes. The 8.8" rear end came out of a 1991 2WD Super Cab...

I just bought a 1991 8.8" open rear end with 3.08 gears from a 2WD Super Cab Ranger with 4.0L (axle code 92). My Ranger has the 7.5" rear with 3.45 gears (axle code 84). Question: in 1991 what gears did the 2WD Super Cab with the 2.9L engine did the 8.8" rear end come with? Google doesn't...

How do I tell if my 1990 Super Cab 2.9l has ABS? It has the 7.5" rear end and 9" rear brakes. It was built Oct 1989. Thanks.

I'm planning on carrying my spare tire on a swing arm frame welded to the bumper. I'm also considering having a Jerry can or two built in as well. Has anyone modified one made for a Jeep to a Ranger truck? Like this...

Since the Ranger 6' beds seem to interchange from 83 to '11, I'm guessing that the bed bolts and the nut clips are all the same. Or are there some years that the bolts are different? Thanks!