Search results

Thank you so. Much for all the help these diagrams are just what I needed I ll let you know when I get it going and will post all the issue I be had and how I fixed them on a new thread for other guys again thanks a million

Thanks Ron for your help I did find the problem I pinched the wire to the dpfe senser and it was shorted out to the intake I have it running good now but the trans will not shift I need to hook the vss sensor up but my hyanse manual is worthless cuz the wires are not the color the manual says...

First off thanks for the replies with my other two questions I now have a trans that will not shift I know it is because of the vss m.y wire diagram in June manual has been less than worthless can someone tell me what wire I need to hook up manual says I should have a pink with orange...

Anyone have a vacuum diagram for a 01 5L I can t find one anywhere and I don t have the sticker from the expo I got engine from

Engine swap cranks no start help Still haven't got ranger to run I put ECM from a 1997 EFI mountaineer in it but still have the same thing as I did with the original ECM from the explorer engine cranks no start. If I use start fluid it fires up I have fuel at the rail power to eec 12v at...

Ron D I have the pats module installed and I also changed the hole steering column so the ranger now has the key switch the halo antenna ring pats module ECM radio and instrument cluster the pats light did blink fast for bout a min then it blinked a 1 pause 6 code for a min then it would...

I put a 01 explorer 5L in my 01 ranger I used the wire harness from expo the radio instrument cluster pats module steering column and ECM all from expo. The truck will crank over but will not start. The theft light was blinking normally. At first then it started to. Blink fast when I...