• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

grinding

  1. Hudsonterry05

    Grinding in All gears

    Hey, I have a 2003 Ranger 4wd manual with a 4.0, Today within the last 100 miles it has started a grinding sound from the transmission. When I start from first it sounds fine, but as soon as I put the clutch in it starts this loud grinding sound and does it all the way through 3rd gear, but...
  2. Grinding Noise Mystery

    Trying to track down a grinding noise⬇️ So I’ve got a grinding noise coining from my front end somewhere. It’s more noticeable at slower speeds. Noise also gets drastically better when brakes are applied. I can hear it when going straight, and it’s worse when turning left. Goes away when...
  3. 2.3L ('83-'97) 93' 2.3 Clutch Issues After Transmission Swap

    I recently converted my 93' ranger to a manual from the a4ld automatic. I'm having trouble getting the clutch to fully disconnect. When the engine is on and I go to put the truck in reverse, it grinds. The transmission goes into gear perfectly when the engine is off. I am able to start the car...
  4. MadMax_636

    Brand new starter grinding on start. Engine starts every time but seems to slip/ not catch all the time.

    1984 Ford Ranger 2.8L V6 5-Speed So, Ive installed a brand new starter. The starter never name this sound until I had a really bad stalling issue where I had to crank my car over every time it would stall. I never held the key tried cranking when it was running. The last time I started when...
  5. Starter problems?

    Hi I am new to this so this may not be the right section. But I was offroading with my 98 xlt and the next day I started the truck and not even a second after it started running i heard a slight grind from the starter I believe for only a split second. So I got under grabbed the starter an it...
  6. Grinding/ scraping from front end while in 4wd

    Hi all, I'm getting a scraping/ grinding noise when 4wd is engaged and I'm looking for possible causes. I'll try to describe it as best I can and give you as much information as I can. The truck is a 2000 Mazda b4000 4x4. Standard transmission. Electronic T-Case. 75000 miles on it. **it has a...
  7. Grinding When Put In 4x4

    Hello, I have a 1994 Mazda b4000, and I've replaced about every single thing on this truck from the engine to transmission, to radiator and alot of smaller things. But the problem I'm having is that when I put it into 4x4 (which works good) it makes a grinding noise from the front end. This...
  8. transmission problems

    my 83 ranger has been giving me issues since i pulled the transimission and replaced a couple parts. nothing was done to the transmission, the rear main seal was replaced and the oil pan gasket. but ever since the trans was pulled out, it has been very difficult to get the truck into first...

Sponsored Ad


Sponsored Ad

Top