-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
neutral safety switch
-
1990 Ranger will not shift to 4x4 Low... unique situation
Hey all! Searched everywhere online and couldn't find an answer, so I hopped on this forum to ask some of you wise folks. I have a very unique Ranger, 1990 single cab, 4.0 v6, automatic but was converted to a manual 5spd. The original electric shift T case was kept. Also has Dodge Dana 60 axles...- MahLahChee
- Thread
- Replies: 14
- Forum: Transfer Cases & Locking Hubs
-
Neutral safety switch location
I ran the paperclip method for my 1992 Ford ranger 2.9l automatic engine and got a code of 67; which is the neutral safety switch, but I can't find it on the truck. Please help! I realized that I didn't touch the brake will doing the KOEO test either, could that be the problem?- 123everlynm
- Thread
- Replies: 8
- Forum: 2.9 Liter Forum
-
1988 Bronco II - No reverse lights, new NSS switch and starting in all gears
Ok so I have no revers lights in my Bronco II - A4LD trans and 4x4. I first replaced the NSS thnking that was the issue - still no lights. Also its starting in all gear positions now. Will get to that later.... As far as the light issue goes - I Tested Purple/Orange wire in harness and have...- 88_B2_Eddie Bauer NJ
- Thread
- Replies: 3
- Forum: Ford Bronco II