Hey guys new here and pretty new to the car scene as well i bought a 1993 Ford Ranger XLT 3.0L v6 automatic with 140,000 miles a few days ago and it was turning on and driving pretty well when this morning it didnt turn on. I tried my best and looked up posts and videos and this is what i have...
Hello!
So I recently picked up a 1985 Ford bronco 2 2.8l v6 as more of a project vehicle I can learn from. Either way, used to run, but now it doesn't after I gave it a tuneup lol
so I'm trying to track down what got it not starting, So, I've checked for spark on sparkplugs got em, got...
Have 93 splash...4.0 ohv
Truck sat for 5 years and im getting it back up n running.
Started right up and drove to my garage then noticed fuel leaking down tank from top. Dropped tank and fuel pump connections were broke n rusted..replaced whole pump assembly and filter, used some gas seal to...
My 1992 2.3 hasn't been short of problems, But now she doesn't even wanna start. When you turn the key to fire the engine its pulls power but then just clicks, no attempt to start. battery is good, all fuses are good. It can be push started. But once running its runs really poorly.
Idea...
I have a 1986 ford ranger reg cab 2.9v6 I have been slowly putting together for about a year now. I have replaced breaks lines and two fenders so far and wanted to get the vehicle drivable before I work on the new floor panels. I had the vehicle turning over perfectly with no problem and it was...
So heres the story, about 3 months ago i drove 2 hours away to look at this 87 ranger stx with the 2.9l v6, when i got there the truck fired right up and seemed to run fine except it idled at about 2000-2200rpm. i figured it would be an easy fix and the truck was cheap so i went ahead and bought...
My friends 88 2.3 used to not want to start after driving.(after operating temp) if you would let it sit later it would be fine, fire up and get you home. Then it decided it wouldnt run, i noticed the pump in the tank was not kicking on, so we replaced the relay, would not start. put a new pump...
ok so i tried doing one thread and some of the people on there were retarded so im starting a new one to try to clear up confusion. first off my problem is that i did a small rebuild on my 2.9Fi motor and re did all the gaskets from top to bottom and cleaned it out and in i droped it back into...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.