Jim Wright
Member
- Joined
- Jul 18, 2021
- Messages
- 30
- Reaction score
- 17
- Points
- 8
- Location
- McCleary Wa
- Vehicle Year
- 1989
- Make / Model
- Ford Ranger
- Transmission
- Manual
So after doing a little investigating. I found I have no 12 volt at positive side of ignition coil. Checked all fuses, all good. My problem is the wiring diagram shows power from ignition switch to coil. I replaced ignition switch still no 12 volts to coil. I am wondering if the positive side of coil gets its supply of 12 volt power from someplace else than ignition switch. Lastly, the power wire that feeds the coil also feeds other components. So basically I'm screwed until I figure it out. Thanks for any insight.
Ranger 2.9
Ranger 2.9