- Joined
- Apr 23, 2021
- Messages
- 7
- Reaction score
- 1
- Points
- 1
- Location
- Hollidaysburg, Pa USA
- Vehicle Year
- 2011
- Make / Model
- Ford Ranger
- Engine Type
- 4.0 V6
- Engine Size
- 4.0
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
Installing a rear camera to my 2011 Ranger XLT Supercab 4x4
Every thing is in except when I went to tap the back up light
both wires on the socket are the same color. What is the correct
way to make sure which side is the 12v. Once I determine that
do I just connect both wire to the socket wiring or do I run
the ground to the frame or somewhere on bed.
Thanks. Going to post this is two forums hoping to get a quick answer.
Every thing is in except when I went to tap the back up light
both wires on the socket are the same color. What is the correct
way to make sure which side is the 12v. Once I determine that
do I just connect both wire to the socket wiring or do I run
the ground to the frame or somewhere on bed.
Thanks. Going to post this is two forums hoping to get a quick answer.