Back Again with another Ranger 4x4

[RonD]

Yes, there is a reverse light switch, drivers side of trans toward the top rear of shifter housing
It unscrews, if its loose then screw it back in and it should work, if its tight I would just replace it

BUT..........make sure wire connector is not the issue, i.e. loose wires at the switch
One wire will have 12volts, key on
The other wire goes to the reverse light bulbs
The reverse shift fork in the trans pushes the "plunger type" switch closed when in Reverse position, which passes the 12v to the bulbs

Not sure on brighter head lights but test with Headlight switch ON, not using DRL head lights, they only run at about 70% power

 

[PaulZ]

Found the reverse light switch, connections clean. I went ahead and removed it since I was under there. Put an ohm meter on the two pins, pushed the ball in, nothing. I assume that's how it works, will replace.

So I've been reading up on the torsion bars, camber kits etc.. It sure looks like mine already has camber adjustment capability, no? Are the kits to adjust it further, or make it easier to adjust? See photo.