adsm08

Ok iv got a 87 stx high rider it olny has 87000 miles onit any I had a problem with the battery cable ends I change the ends now the truck won't start it's spinning firing and getting fuel to the rail can't figure it out I've traced grounds the only thing I haven't checked is if I'm getting the constant 40 pounds at the rail but I'm getting power to my injectors I've changed out my relays what gives man you seem to be

Question For ya. I was looking at one of your old posts and you said that a 1989 bronco II with a 2.9 L does not have a crankshaft position sensor. I have a 1988 Ranger STX 2.9 L. Same thing? You see, I am driving and occasionally in each gear when I try to accelerate my rpms will not go over 3000 for any of my gears. Any ideas? If you could email me at dtauber1993@gmail.com that would really help me out. I am a little confused. Thanks!

Travelled through your neck of the woods today on I-80W. Northumberland County, PA, right? We're returning to TN from visiting family in (believe it or not) Groveton (Northumberland), NH. Beautiful country. When I saw the road sign I thought "Hey, there's a Ranger buddy somewhere near...)

I appreciate your replies in on my help thread. Thank you very much!

hey there need a little tool help my work van got robbed so the tools i had for working on my ranger have not all been replaced yet but i want to replace my carrier bearing and can't figure out what size wrenches or sockets i need to get the flange yoke off and the u-joint strap bolts i had a kit made up for these but must have been in the van got robbed. 1993 ford ranger 4x4 super cab 4.0 auto thanks !!!!

Thanks, I appreciate it...

$50 plus shipping?

ive got a 96 ranger that i just put in a new flex plate..... after everything was installed i started it up and put in drive and i got nothing.... it like i have no gears... the trans was rebuilt about a year ago and a new torque converter was installed... i had no problems wat so ever when i put in the trans a year ago

Theres is a faint grinding noise that sound like its coming from the bell housing..... would a bad rear diff prevent the truck from moving

You commented on my thread about this. do you think replacing the torque converter would solve the issue

Looking for 95-98 manual trans pedal bracket. Conducting an experiment for the betterment of all Ranger-kind.

I have a manual trans pedal bracket if your still looking

Hello sir. I just got a 4.0 w/ 60,000 miles on it. 1994/2wd/5spd. No issues, drives like new. Just wondering your thoughts on the truck, mainly the engine.