'92Custom
Member
- Joined
- Apr 3, 2011
- Messages
- 59
- Reaction score
- 2
- Points
- 8
- Location
- Alexandria, VA
- Vehicle Year
- 1992
- Make / Model
- Ford
- Engine Size
- 4.0 V6
- Transmission
- Manual
I'm in the middle of a multi-week project on my Ranger. Among other things, I need to replace the clutch, flywheel, and rear main seal.
In reading about the rear main seal, a few people have mentioned using a tool to seat the seal. Others have said it is not necessary but I don't want to risk a bad installation on a part that is so difficult to get to.
The part number I found is:
OTC 7834
https://www.amazon.com/OTC-7834-Rear-Crankshaft-Installer/dp/B000RMMS9W/ref=cm_cr_arp_d_product_top?ie=UTF8
Problem is in compatibility it lists only 1993+ 4.0 engines.
Is there a specific tool for the 92 and earlier 4.0? Or should they all be the same? Can't seem to find a compatible part #.
Thanks.
In reading about the rear main seal, a few people have mentioned using a tool to seat the seal. Others have said it is not necessary but I don't want to risk a bad installation on a part that is so difficult to get to.
The part number I found is:
OTC 7834
https://www.amazon.com/OTC-7834-Rear-Crankshaft-Installer/dp/B000RMMS9W/ref=cm_cr_arp_d_product_top?ie=UTF8
Problem is in compatibility it lists only 1993+ 4.0 engines.
Is there a specific tool for the 92 and earlier 4.0? Or should they all be the same? Can't seem to find a compatible part #.
Thanks.