vitalka89
New Member
- Joined
- Oct 31, 2012
- Messages
- 16
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 2001
- Make / Model
- Ford
- Transmission
- Manual
Hey guys I am new to this forum. I recently picked up a 2001 Ranger Edge with the 3.0L in it. I started having problems with the clutch pedal and have tried researching everywhere and can't seem to find an answer. It is similar to the problem many people are having with this failure of a clutch system, but mine corrects itself than goes bad constantly. I will drive it for a week with the clutch pedal feeling good like its supposed to than all of a sudden it starts catching lower and lower to the point where you barely release it from the floor and it's catching than all of a sudden I hop in and the pedal is dead on again, yesterday it was catching at a point where I had to shut the truck off to put it in gear. I am curious if this sounds like a master cylinder problem where I need to bleed the clutch or does it sound like the slave cylinder inside the tranny. I don't want to start tearing everything apart and changing parts that don't need change if I don't have to.