zpexploder
New Member
- Joined
- May 25, 2008
- Messages
- 1
- Reaction score
- 0
- Points
- 0
- Age
- 45
- Transmission
- Automatic
Which of the 4 wires on my 96 explorer 5.0 is the voltage output?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
o2 sensor wires
- Thread starter zpexploder
- Start date
V8 Level II
Dec 2008 STOTM Winner, 2008 Truck Of The Year
U.S. Military - Veteran
V8 Engine Swap
MTOTM Winner
RBV's on Boost
- Joined
- Apr 29, 2008
- Messages
- 331
- Reaction score
- 4
- Points
- 18
- Location
- Michigan
- Vehicle Year
- 2003
- Make / Model
- Ford
- Engine Size
- Supercharged 5.0L
- Transmission
- Automatic
These are the color codes for the front O2 sensors in the truck harness:
DS: red/black
(to PCM pin 87)
PS: gray/light blue
(to PCM pin 60)
Bosch sensors usually use a solid black signal wire in the pigtail of the sensor itself. Each black wire should plug to the corresponding harness color code shown above.
DS: red/black
(to PCM pin 87)
PS: gray/light blue
(to PCM pin 60)
Bosch sensors usually use a solid black signal wire in the pigtail of the sensor itself. Each black wire should plug to the corresponding harness color code shown above.
Sponsored Ad
Sponsored Ad
Today's birthdays
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Truck of The Month
Shran
April Truck of The Month
Recently Featured
Follow TRS On Instagram
TRS Events
25th Anniversary Sponsors
Check Out The TRS Store
Sponsored Ad
Sponsored Ad
Sponsored Ad
Amazon Deals
