crazyracer695
New Member
- Joined
- Dec 9, 2007
- Messages
- 8
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1991
- Make / Model
- Ford
- Transmission
- Automatic
I have a 91 Ford Explorer and I put a wagoneer 44 under the front and toyota v6 axle under the back. I went to bleed the brakes and all four wheels bled fine with no air and when its not running it will build pressure after a few pumps but lose it after like 30 seconds. With it running it wont build pressure at all. My RABS light is on all the time now too. I bench bled my master cylinder also. I cant figure out where the air is or why it wont build pressure. Any suggestions?