acreature
Member
- Joined
- Sep 25, 2018
- Messages
- 45
- Reaction score
- 0
- Points
- 6
- Location
- Kill Devil Hills
- Vehicle Year
- 1996
- Make / Model
- Ford
- Transmission
- Automatic
1996 XLT 4.0 4wd fixer-upper purchase
Got suspension repaired, the motor running as it should, now to tackle the AC.
Clutch does not engage when switched to AC. Will not take freon without clutch engaged. All fuses are good, WOT relay is good.
Clutch will engage when jumped at the compressor, but will still not take freon when done so.
Tested the plugs to the pressure switches (high and low) and get no voltage (if I did it correctly). This is where I am lost without guidance, as to where to go next. As far as testing the switches/sensors themselves, I felt was moot since I did not get and voltage to the pigtails.
Any step by step help would be greatly appreciated.
Got suspension repaired, the motor running as it should, now to tackle the AC.
Clutch does not engage when switched to AC. Will not take freon without clutch engaged. All fuses are good, WOT relay is good.
Clutch will engage when jumped at the compressor, but will still not take freon when done so.
Tested the plugs to the pressure switches (high and low) and get no voltage (if I did it correctly). This is where I am lost without guidance, as to where to go next. As far as testing the switches/sensors themselves, I felt was moot since I did not get and voltage to the pigtails.
Any step by step help would be greatly appreciated.