Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Ill look over that section a bit better then. Once it said breakout box i skipped on past.
I was doing some testing again today.....i may or may not have it figured out, lemme run it by yall...My breakout box is a set of sewing needles and alligator clips for my meter
Pierce the wires for testing then turn on the key or start the engine, which ever is needed for the test
One heads up, don't pierce wires so sewing needles can touch each other or ground out, stupidly been there done that, lol.
Well with a new TFI module and no PIP codes why am i only getting 6 volts at the spout?
Did you have a chance to do this?
Have not. Didnt have my phone when i went last time.
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
