Welcome Visitor! Please take a few seconds and wyotecher20
New Member
- Joined
- Apr 9, 2010
- Messages
- 1
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1989
- Make / Model
- Ford
- Transmission
- Manual
I just finished swapping a 4.0 into my '89 ranger that had a 2.9 with over 400,000 original miles on it. The swap went well and the truck runs great. The engine is a 4.0 out of a '91 Areostar van. The problem I am having is that the hood does not clear the engine's intake manifold and will not shut. I used the 2.9 motor mounts and the motor mount brackets from the 2.9 as the brackets from the Aerostar were different. So my question is, are the metal brackets that bolt to the sides of the engine different on the ranger/explorer than on the aerostar?? Thanks.
