Beer tap shifter write up:
1. Acquire beer tap handle of your choice (usually pretty cheap on ebay. Most are threaded at the bottom)
2. Find a bolt of correct pitch and size for the handle
3. Remove knob, boot, and shifter.
4. Line up the handle with the shifter and decide how tall you want your handle to be (mines about 3" taller than stock). Mark that spot on the shifter.
5. Cut the shifter at that spot and smooth off the top.
6. Thread the bolt into the shifter so you know where it stops. Figure out which direction the tap should go and butt it up against the cut end of the shifter. mark a spot on the head of the bolt and on the shifter so you can line it up.
7. Remove tap handle and weld bolt to shifter according to your marks.
8. Reinstall shifter and boot. Push boot down tight against weld (mine fit perfect) or trim the old boot to fit the way you want.
9. Thread on tap handle.
10. Rock on. "Officer, I swear to drunk I'm not god."