Mirage775
Member
- Joined
- Dec 16, 2016
- Messages
- 63
- Reaction score
- 5
- Points
- 8
- Location
- Huntsville, AL
- Vehicle Year
- 2003
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Manual
I've been looking and searching for the proper way to go about installing rear disc brakes on my '03 Ranger 4x4 and just need a little more assistance with it?
I've found more information about swapping rear ends in pre 98 Rangers more than anything, but that's not what I need in this case?
First off, I have an 8.8 diff with 4:10 OE gears. I'll measure the axle housing today, once the rains dies down a bit. And I would like to use an complete Explorer diff/axle setup, that requires no welding, so that I'll still have my e-brake cables more or less in the same areas, as I have a manual and always use the e-brake.
If anyone can help me out, I'd appreciate it?
Thanks
I've found more information about swapping rear ends in pre 98 Rangers more than anything, but that's not what I need in this case?
First off, I have an 8.8 diff with 4:10 OE gears. I'll measure the axle housing today, once the rains dies down a bit. And I would like to use an complete Explorer diff/axle setup, that requires no welding, so that I'll still have my e-brake cables more or less in the same areas, as I have a manual and always use the e-brake.
If anyone can help me out, I'd appreciate it?
Thanks